I finished binding and labeling Dutch Treat yesterday. The rain held off just long enough for a few shots taken in the back yard:
Red and green look so good together, don’t they?
Here you can see the entire quilt:

The windmill blocks measure 12″ square and the pinwheels in the center of each block measure 4″ square. The block is a variation of the classic Winding Ways quilt block usually made with curved seams. These seams are straight but the overall design of the quilt gives the illusion of overlapping circles.
On the back of the quilt I used leftover blocks:

I know what you’re thinking: “Wow, that’s a lot of leftover blocks.” You’re right — and I didn’t even use all of them. I confess: those extras resulted from a miscalculation on my part. At least I was able to put most of them to good use.
Here’s a close-up of the label:

I made the label round using a compact disc for a pattern (described in my tutorial) and then set the label inside a larger circle of red fabric so it would stand out against the backing fabric.

I’m so pleased with the quilting of longarmer Debbie Scroggy. You can see close-ups of Debbie’s quilting in this earlier post.

Dutch Treat (named for the windmill-shaped block)
48″ x 60″
Adapted from the pattern A Mid-Winter’s Night by Cottage Rose
Fabrics: a mix of reds and two light background prints, all from my stash
Quilted by Debbie Scroggy of All Quilted LLC
To read older posts about the making of Dutch Treat, click on the category “windmill block” at the bottom of this post.
Thanks for stopping by. It’s always fun to share a finish!

































